TITLE

Properties of laser and amplified signal in a gain-clamped Er3+-doped fiber amplifier system

AUTHOR(S)
Teyo, T. C.; Mahdi, M. A.; Poopalan, P.; Ahmad, H.
PUB. DATE
March 2000
SOURCE
Microwave & Optical Technology Letters;3/20/2000, Vol. 24 Issue 6, p418
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
The effects of a lasing wavelength and probe signal on each other in a gain-clamped Er3+-doped fiber amplifier system are presented. The signal gain was found to be dependent on the lasing wavelength. This was not the case for the noise figure where the lasing wavelength did not have any significant effect on noise performance. The laser power and excess pump power were constant at low input signal levels; however, they started to reduce at high input signal powers. © 2000 John Wiley & Sons, Inc. Microwave Opt Technol Lett 24: 418–420, 2000.
ACCESSION #
13449313

 

Related Articles

  • Gain enhancement in L-band EDFA using a fiber Bragg grating. Harun, S. W.; Poopalan, P.; Ahmad, H. // Microwave & Optical Technology Letters;3/5/2002, Vol. 32 Issue 5, p388 

    Gain enhancement in a long-wavelength band (L-band) erbium-doped fiber amplifier (EDFA) is demonstrated using a broadband fiber Bragg grating (BB FBG) that reflects the L-band amplified spontaneous emission (ASE) and L-band signal back into the system. The reflected L-band signal is then pumped...

  • Efficient multiwavelength generation of Brillouin/erbium fiber laser at 1600-nm region. Harun, S. W.; Tamchek, N.; Poopalan, P.; Ahmad, H. // Microwave & Optical Technology Letters;12/20/2002, Vol. 35 Issue 6, p506 

    An efficient Brillouin/erbium fiber laser, which operates in the 1600-nm (L-band) region, is demonstrated for potential applications in future dense-wavelength division multiplexing communication systems. The laser configuration consists of an L-band EDFA (to enable L-band amplification) where...

  • Low-threshold characteristics of a linear-cavity multiwavelength brillouin/erbium fiber laser. Al-Mansoori, Mohammed H.; Bouzid, Belloui; Saharudin, Suhairi; Ali, Borhanudin M.; Abdullah, Mohamad K.; Mahdi, Mohd A. // Microwave & Optical Technology Letters;4/20/2004, Vol. 41 Issue 2, p114 

    A novel operation scheme of a multiwavelength Brillouin/Erbium fiber laser (BEFL) utilizing a linear cavity is presented. Twenty-two stable output laser lines with 10.88-GHz (0.088-nm) line spacing at 1558 nm were obtained from this architecture without the need of internal feedback. A low...

  • Hybrid Distributed Raman/EDFA Amplifier with Hybrid Automic Gain Control for Reconfigurable WDM Optical Networks. Oliveira, Juliano R. F.; Moura, Uiara C.; Oliveira, Júlio C. R. F.; Romero, Murilo A. // Journal of Microwaves, Optoelectronics & Electromagnetic Applica;Dec2013, Vol. 12 Issue 2, p602 

    Nowadays, optical amplifiers designs are induced by new requirements generated by optical networks. The introduction of WDM reconfigurable networks with increasing rate from 10-40 Gb/s to 100 Gb/s and beyond, demand new optical amplifiers development with improved gain spectral flatness and...

  • The future of optical networking. Affolter, Kevin // Lightwave;Aug2001, Vol. 18 Issue 9, p134 

    Focuses on the application of dense wavelength division multiplexing (DWDM) and tunable lasers for the increase fiber capacity of Internet service providers. Characteristics of fiber-optic networks; Applications of tunable lasers in addressing the limitations of DWDM; Benefits of widely tunable...

  • S-BAND BRILLOUIN/ERBIUM FIBER LASER FOR DWDM APPLICATION. HARUN, SULAIMAN WADI; SAN, CHENG XIAU; AHMAD, HARITH // Journal of Nonlinear Optical Physics & Materials;Sep2006, Vol. 15 Issue 3, p309 

    A multi-wavelength Brillouin erbium fiber laser (BEFL) which operates in a short wavelength band (S-Band) is demonstrated using a depressed cladding erbium-doped fiber (EDF). Two 80/20 couplers were used in the system for internal feedback of generated stokes signal in order to produce cascaded...

  • Single Longitudinal Mode Fiber Laser Based on Saturated Absorber. Wu Pan; Hong lin Zhang; Zheng ke Xu; Hui Zhang // Advanced Materials Research;2014, Issue 1044-1046, p426 

    In order to realize single longitudinal mode (SLM) output, an erbium-doped fiber (EDF) laser with fiber ring cavity is proposed which uses an un-pumped EDF saturated absorber as a SLM selector. Ring cavity length, coupler ratio and insertion loss which affect ring cavity filter performance are...

  • 100 nm gain bandwidth amplifier based on 980 nm pumped cerium codoped fluoride EDF. Akasaka, Y.; Kubota, Y.; Sakaguchi, S.; White, I.; Pan, J. // Electronics Letters;5/29/2003, Vol. 39 Issue 11, p836 

    Reports on the development of wavelength multiplexed pumping for distributed Raman amplification in earth doped fiber amplifiers (EDFA) utilizing 100 nanometer of optical fibre bandwidth for high bit-rate wavelength division multiplexing transmission. Reason for the flat gain spectrum of...

  • EDFA achieves 94-nm bandwidth.  // Laser Focus World;Sep2005, Vol. 41 Issue 9, p9 

    Reports on the development of a coupled-structure S-to-C-band amplifier with a 94-nanometer gain bandwith from 1476 to 1570 nanometer by scientists at the National Chiao Tung University and the Industrial Technology Institute, Chungwa Telecom Co. and Yuan Ze University in Taiwan. Construction of...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics